Legacy Lockdown Upgrades (G-Works Pre-Order)

A set of parts for your Legacy Lockdown figure.

Hook mount - Designed to replace the right hand of the original figure. This can swivel like the hand, for transformation purposes. It has a 5mm socket for mounting the original toy's hook to.

Peg extensions - These small 5mm diameter cylinders screw into the end of the pegs for the exhaust pieces the original toy comes with. This allows those pieces to be pegged into the shins of the figure, in a way that better resembles the original Animated Lockdown.

Wheel Spikes - These 5mm peg spikes plug into the wheels of the Lockdown figure to better resemble his earlier figures and designs.

Simply remove the original right hand and use a blunt tool to push the peg of the replacement wrist mount into place. The peg extensions screw into the ends of the exhaust piece pegs, as shown in the image, but be careful not to over-tighten the screws. If the extension cracks due to over tightening, a little superglue, left to dry for a few hours, should repair it just fine. The spikes just need to be removed from the sprue and then inserted into the wheel sockets - As tolerances vary, the part was designed with excess "fins" you can trim down until it's a snug fit.

Colours may vary and may not be perfectly matched to the original figure. Sold as a set of unassembled pieces, figure is not included. May require assembly and removal from sprues. Customer responsible for all assembly and risks involved.

There may be variance in tolerances as each set of parts is individually 3D printed. Please DO NOT expose these to a significant amount of UV light (such a strong, direct sunlight) before/during assembly, as it will cause them to become more brittle.

Product is custom accessory meant to augment your figure, not a Transformers branded item.