Hip Ratchets for Prime Wars Trilogy Combiners

Read the PRE-ORDER AND SHIPPING INFO before placing any order.

Do not order unless you accept these terms.

Going back to where it all began (for me as a designer), these 3d printed hip ratchet pieces replace the ones for either the hips of the CW Optimus mould (including Menasor), the shoulders of the CW Silverbolt mould (including Cyclonus and Scattershot) or the shoulders of PotP Hun-Grr and Selects SnapTrap. These are the joints that become the hips for their combined forms. While Hun-Grr/SnapTrap use the same engineering as Silverbolt in many areas, they have different ratchets and thus a different part is needed, please order carefully.

These pieces have twice as many "clicks" as the original ratchets, allowing your figures to pose more naturally, as illustrated in the photos, rather than having to spread legs or arms at such an extreme angle. These photos also feature other add-on parts which are not included, only the hip ratchet pieces.

Colors may vary but are typically grey resin. Sold as a set of unassembled pieces, figure is not included. May require assembly and removal from sprues. Customer responsible for all assembly and risks involved.

There may be variance in tolerances as each set of parts is individually 3D printed. Please DO NOT expose these to a significant amount of UV light (such a strong, direct sunlight) before/during assembly, as it will cause them to become more brittle. Once fitted to your figures they will be sufficiently hidden. The sharp edges of the ratchets will wear down slightly on first use but this does not affect their utility. Over-tightening the screws when reassembling can also cause the ratchets to break under the stress.

Product is custom accessory meant to augment your figure, not a Transformers branded item.